2-45
Installing and Setting up the Machine > Network Setup
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
Display the screen.
[Home] key > [...] > [System Menu] > [Network Settings] > " Network Settings" [Wi-Fi Direct Settings]
2
Configure the settings.
[Wi-Fi Direct]: [On] > [OK]
3
Restart the network.
[Home] key > [...] > [System Menu] > [Network Settings] > " Network Settings" [Restart Network] >
[Restart]
4
[Home] key > [Device Information] > [Wi-Fi Direct/Wi-Fi]
5
Press the push button on the computer or handheld device and select [Push Button]
on the screen of operation panel simultaneously.
The network between this machine and the computer or handheld device is configured.
You can connect up to 10 handheld devices at the same time using Wi-Fi Direct setting. When the
devices that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the
already-connected devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
Select [Home] key > [Device Information] > [Wi-Fi Direct/Wi-Fi] > "Wi-Fi Direct" [Device] > [Disconnect
All] > [Disconnect]
• Configuring auto disconnecting time from the System menu
Wi-Fi Settings (page 8-40)
• Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
To Next Page
Loading...
Need help?
General