8-9
Setup and Registration (System Menu) > System Menu
Weekly Timer Settings
Configure settings for switching the machine into Sleep mode and waking it
automatically at a specified time for each day of the week.
Weekly Timer
Select whether to use Weekly Timer.
Value: Off, On
Schedule
Specify the time for each day of the week at which the machine enters Sleep mode and
recovers.
Retry
Set the number of retry to switch the machine into Sleep mode.
Value: Limited Retries, Unlimited Retries
•If [Limited Retries] is selected, set the number of retry. The setting range is 0 to 10.
•If [Unlimited Retries] is selected, retry is performed until the machine enters Sleep
mode.
Retry Interval
Set the retry interval.
Use [-] / [+] to enter a number.
Value: 10 to 60 seconds (increments of 10 seconds)
Power Off Timer (models
for Europe)
Select whether to turn off the power automatically after a period of inactivity.
Value: 1 hour, 2 hours, 3 hours, 4 hours, 5 hours, 6 hours, 9 hours, 12 hours, 1 day, 2
days, 3 days, 4 days, 5 days, 6 days, 1 week
Power Off Rule (models
for Europe)
Select whether or not the machine enters Power Off mode for the following function.
Select [On] to set the Power Off mode.
•Network
•Fax
•USB Cable
•USB Host
• Application
•NIC
• Remote Diagnostics
Value: Off, On
• Even when any of the functions is set to [On], if either [Fax] or [NIC] is set to [Off], the
machine does not enter Power Off Mode.
•Even when [Network] or [USB Cable] is set to [Off], if the machine does not
communicate with the other devices, the machine will enter Power Off Mode.
•[Fax] is Displayed only when the optional FAX Kit is installed.
•[NIC] is displayed when the optional Network Interface Kit or Wireless Network
Interface Kit is installed.
Energy Saver Recovery
Level
Select the method of recovery from energy saver.
Value:
Full Recovery: This mode enables the use of all functions immediately.
However, this mode saves less energy.
Normal Recovery: In this mode, you can select the method from the following: enabling
the use of all functions immediately or enabling the use of desired functions only.
If you want to use all functions immediately, select the [Energy Saver] key to execute
recovery.
Ping Timeout
Set the time until timeout occurs when [Ping] is executed in "System/Network".
Value: 1 to 30 seconds (in 1 second increments)
*1 This function will not be displayed when the optional Network Interface Kit or Fiery controller is installed.
*2 Displayed when the optional Card Authentication Kit is activated.
Item Description
To Next Page
Loading...
Need help?
General