6-11
Using Various Functions > Functions
Punch
Punches holes in sets of finished documents.
Original Orientation and Punch Hole Position
• This function requires the optional Document Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Punch Unit (For 1,000-Sheet/4,000-Sheet Finisher)
(page 11-24)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item Value Description
Punch Off
2 holes Left Select the position of punch holes. For details on original
orientation and position of punch holes, refer to the
following:
Original Orientation and Punch Hole Position (page
6-11)
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original orientation Portrait Landscape
Paper orientation
Cassette paper load
direction
Cassette paper load
direction
The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
To Next Page
Loading...
