6-25
Using Various Functions > Functions
Job Finish Notice
Sends E-mail notice when a job is complete. It is also available that send a notice when a job is interrupted.
Users can be notified of the completion of a job while working at a remote desk, saving the time spent waiting beside the
machine to finish.
File Name Entry
Adds a file name.
Additional information such as job number and date and time can also be set. You can check a job history or job status
using the file name, date and time, or job number specified here.
Select [File Name], enter the file name (up to 32 characters
), and select [OK].
To add date and time, select [Date and Time]. To add job number, select [Job No.]. The added information will be
displayed in "Additional Info".
Priority Override
Suspends the current job and gives a new job top priority.
The suspended job resumes after the other job is finished.
(Value: [Off] / [On])
• PC should be configured in advance so that E-mail can be used.
Command Center RX
(page 2-51)
• E-mail can be sent to a single destination.
Item Description
Off
Address Entry Enter E-mail address directly. Select [E-mail Address], enter the address (up to 128
characters) and select [OK].
Notify when
interrupted
Add a check mark if you require an e-mail notification when a job is interrupted.
• This function is not available if current job was an override.
• Priority override may not be available depending on the status of the current print job and memory usage.
Functions
Functions
To Next Page
Loading...
