Kyocera ECOSYS P4060DN - Replacing Staples (Folding Unit)

10-10
Troubleshooting > Regular Maintenance
Replacing Staples (Folding Unit)
When the Staple Unit runs out of staples, the following messages will be displayed. The staple cartridge holder need to
be replenished with staples.
"Staple is empty."
1
Open the finisher front cover 1 and 2.
2
Remove the Staple Cartridge Holder (B) or (C).
3
Replace the staples.
NOTE
If the Staple Unit runs out of staples, contact your dealer or service representative.
C
B
1
1
2
1
1
2