10-19
Troubleshooting > Troubleshooting
Printed Image Trouble
When the following printed image trouble occurs, implement appropriate procedures.
Symptom Checkpoints Corrective Actions
Reference
Page
Printouts are totally too
light.
Is the paper damp? Replace the paper with new paper. page 3-2
Is EcoPrint mode enabled? Disable [EcoPrint] mode. page 8-15
―Run [Developer Refresh]. page 10-35
―Run [Laser Scanner Cleaning]. page 10-34
― Make sure the paper type setting is
correct for the paper being used.
page 8-12
White background parts
of the image appear to
have a slight overall
coloration.
Run [Calibration]. page 10-34
Black or color dots appear
on the white background.
―Run [Developer Refresh]. page 10-35
Printouts are fuzzy.
Printouts are cut off.
Is the device used in an
environment with high humidity or
where the temperature or humidity
changes suddenly?
Use in an environment that has
suitable humidity.
―
Set [Drum Heater] to [On]. page 8-53
―Run [Drum Refresh]. page 10-34
Images are skewed. Is the paper loaded correctly? Check the position of the paper
width guides.
page 3-4
Printouts have vertical
lines.
―Run [Laser Scanner Cleaning]. page 10-34
To Next Page
Loading...
