Kyocera FS-C2026MFP

2KW/2KX
1-4-17
3100 ISU home position error
The home position is not cor-
rect when the power is turned
on or at the start of copying
using the table.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Home position sensor and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
ISU motor and main PWB (YC36)
Defective home
position sensor.
Replace the home position sensor.
Defective ISU
motor.
Replace the ISU motor.
Defective CCD
PWB.
Replace the scanner unit (see page 1-5-47).
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation (see page 1-5-29).
3200 Exposure lamp error
When input value at the time
of exposure lamp illumination
does not exceed the threshold
value between 5 s.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Exposure lamp and inverter PWB (CN2)
Inverter PWB (CN1) and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
Defective exposure
lamp.
Replace the scanner unit (see page 1-5-47).
Defective inverter
PWB or CCD
PWB.
Replace the scanner unit (see page 1-5-47).
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation (see page 1-5-29).
3300 AGC error
After AGC, correct input is not
obtained at CCD.
Defective connec-
tor cable or poor
contact in the con-
nector.
Reinsert the connector. Also check for conti-
nuity within the connector cable. If none,
replace the cable.
Inverter PWB (CN1) and CCD PWB (YC3)
CCD PWB (YC1) and main PWB (YC8)
Defective exposure
lamp.
Replace the scanner unit (see page 1-5-47).
Defective inverter
PWB or CCD
PWB.
Replace the scanner unit (see page 1-5-47).
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation (see page 1-5-29).
Code Contents Causes
Check procedures/
corrective measures