Kyocera KM-2530 - Page 107

CHAPTER 6 COPIER MANAGEMENT
6-33
•
Display register key
Sets whether or not to display the Register key in the copy op-
eration screen. The settings can be done by touching the Reg-
ister key in each screen.
Display the “Copy default” screen. (See (5) Accessing
the copy default setting mode.)
Select “Display register key” in the setting item list at the
left-hand side of the screen, and then touch the [Change
#] key.
The “Display Register key” screen will appear.
To display the [Register] key, touch the [On] key.
NOTE
• To cancel the settings, touch [Back] key. The display will return
to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Default setting menu”
screen.
•
Preset limit
Limit the number of copies that can be made at a time.
Display the “Copy default” screen. (See (5) Accessing
the copy default setting mode.)
Select “Preset limit” in the setting item list at the left-
hand side of the screen, and then touch the [Change #]
key.
The “Preset limit” screen will appear.
Touch the [+] key or [–] key to select copy preset in one
job.
NOTE
• To cancel the settings, touch [Back] key. The display will return
to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Default setting menu”
screen.
1
2
3
4
5
Inch specifications
Metric specifications
Inch specifications
Metric specifications
1
2
3
4
5
Inch specifications
Metric specifications
Inch specifications
Metric specifications