Kyocera KM-2530 - Page 106

CHAPTER 6 COPIER MANAGEMENT
6-32
•
Default erase width
Set the initial value of the erasing border width for the sheet erase
or the outer erasing border for the book erase in the border erase
mode.
Display the “Copy default” screen. (See (5) Accessing
the copy default setting mode.)
Select “Default erase width” in the setting item list at the
left-hand side of the screen, and then touch the [Change
#] key.
The “Default erase width” screen will appear.
Touch the [+] key or [–] key to adjust erase width.
NOTE
• To cancel the settings, touch [Back] key. The display will return
to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Default setting menu”
screen.
•
Default margin width
Set the initial value of the margin width for the left margin in the
margin copy mode.
Display the “Copy default” screen. (See (5) Accessing
the copy default setting mode.)
Select “Default margin width” in the setting item list at
the left-hand side of the screen, and then touch the
[Change #] key.
The “Default margin width” screen will appear.
Touch the [+] key or [–] key to adjust left margin width.
NOTE
• To cancel the settings, touch [Back] key. The display will return
to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Copy default” screen.
Touch the [Close] key.
The display will return to the “Default setting menu”
screen.
1
2
3
4
5
Inch specifications
Metric specifications
Inch specifications
Metric specifications
1
2
3
4
5
Inch specifications
Metric specifications
Inch specifications
Metric specifications