Kyocera KM-2560

Preparation Before Use
2-2 OPERATION GUIDE
Selection of Telephone Line (Inch version only)
Select the telephone line according to the type you are contracted with.
Please note that selecting a wrong telephone line will prevent you from
sending fax.
NOTE: If you install the Dual FAX option and then use 2 phone lines,
select the option for each line.
1
Press the System Menu key.
2
Press [FAX/i-FAX], [Next] of Transmission, [Next] of FAX, and then
[Change] of FAX Port 1 or FAX Port 2 (option).
3
According to the type
of telephone line you
are contracted with,
press [Tone (DTMF)]
or [Pulse (10PPS)].
4
Press [OK].
5
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Status
FAX - FAX Port
Set FAX port.
Cancel OK
6/6/2006 10:00
Tone(DTMF) Pulse(10PPS)