Kyocera KM-2560

FAX Operation (Basic)
OPERATION GUIDE 3-11
FAX Automatic Reception
When using this machine as a FAX-dedicated machine that does not
receive telephone calls, set the machine to FAX-dedicated reception. No
special operation is required when receiving faxes.
NOTE: When you are receiving DRD service from a telephone company,
change the reception method to [Auto (DRD)]. For details, refer to DRD
Reception (Available for inch versions only) on page 5-7.
Reception Method
This machine allows the following five reception methods.
• Auto (Normal)
• Auto (FAX/TEL) (Refer to page 5-2.)
• Auto (TAD) (Refer to page 5-4.)
• Auto (DRD) (Refer to page 5-7.)
• Manual (Refer to page 4-13.)
Checking and Changing the Reception Method
1
Press the System Menu key.
2
Press [FAX/i-FAX], [Next] of Reception, [Next] of FAX, and then [Change]
of RX Setting.
3
Select [Auto (Normal)].
4
Press [OK].
5
To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Reception Starts
1
When a fax has been sent to you, the machine rings the registered number
of times, and then starts receiving the fax.
After reception has started, the Receive indicator blinks.