Kyocera KM-2560

FAX Operation (Advanced)
OPERATION GUIDE 5-63
8
Press [Use] and use
the numeric keys to
enter the encryption
box number
(4 digits), and press
[OK].
9
Press [OK].
10
Press [OK].
11
Press the Start key. The transmission will start.
Operation at the Receiving System
To conduct encryption communication operating the receiving system,
follow the steps below.
NOTE: In encryption communication, sub address communication
cannot be used.
1
Register the encryption key you have arranged with the sending system.
(Refer to Registering an Encryption Key on page 5-60.)
2
Press the System Menu key.
3
Press [FAX/i-FAX], [Next] of Reception and [Change] of Encryption RX.
4
Press [On], select
the encryption key
number and press
[OK].
5
The sending system conducts encrypted transmission. When encryption
communication is conducted normally, the machine decrypts the
encrypted originals received and prints the originals.
Status
OK
6/6/2006 10:00
Enter box number using numeric keys.
Cancel
Destination
Not Use
FAX No. Entry - Encryption Box
0
0002
Use
Box No.
Ready to send.
Enter Destination.
Status
FAX - Encryption RX
OK
6/6/2006 10:00
Encryption key No.
Off
1/1
On
Cancel
Decrypt the received data.
Select the key to decrypt.
Key
Key
01
02