Kyocera KM-2560

FAX Operation (Basic)
3-4 OPERATION GUIDE
Direct Transmission (When originals are placed in the document
processor)
After the telephone line has connected with the receiving system, scanning
of the originals placed in the document processor starts. When multiple-
page originals are placed, each page is scanned after the previous one is
sent.
Direct Transmission (When originals are placed on the glass
surface)
This method is suitable for sending book originals that cannot be placed in
the document processor. After the telephone line has connected with the
receiving system, the originals placed on the glass surface are scanned
and sent.
NOTE: When continuous scan is set, you can continue with scanning of
a next original after an original on the glass surface has been sent. Every
time one page is scanned, you perform an operation to allow continued
scanning.
Placing Originals
3
Place the originals on the glass surface or in the optional document
processor. Refer to the machine’s Operation Guide for placing originals.
Dial the Receiving System
4
1 Press [FAX No.
Entry].
Status
6/6/2006 10:00
Enter Destination.
Ready to send.
Destination
Destination
Detail
Address Book
FAX No.
Entry
Folder Path
Entry
E-mail
Addr Entry
Chain Detail/Edit Delete Recall
Destination Quick Setup
Type of Original/
Transmission
Color/Image Advanced
Setup
No.
0
1/1
1/10
001 002 003 004 005
006 007 008 009 010
Free
A OFFICE i-FAX
Addr Entry