Kyocera KM-2560

FAX Operation (Application)
4-14 OPERATION GUIDE
1 Press the Status/Job
Cancel key.
2 Press [Device/
Communication ],
and then
[Manual RX].
Reception will
start.
NOTE: When using a telephone set that can send tone signals, use the
telephone to start the reception of originals with the remote switch
function. (Refer to Remote Switch Function on page 5-9.)
When you hear a voice from the receiving system
The telephone line has connected to the telephone of the sending system.
When the conversation is over, follow steps 1 to 2 above.
After the sending system has started transmission, the machine starts
receiving originals.
4
When reception starts (when the Receive indicator on the operation panel
starts blinking), return the handset to its original position.
Status
Status
Ready.
Device/
Communication
Paper/Supplies
6/6/2006 10:00
Scanner
Ready.
Printer
Not connected.
Removable Memory
Hard Disk
Not connected.
Memory Card
Storing JobsSending JobsPrinting Jobs
Format Remove
Line Off Manual RX
FAX Port 1
Log
Format Printing list
FAX
Ready.
Check New FAXFAX/i-FAX