Other Features of this Fax
5-20
6
Press the [Password] key.
7
If necessary, use the numeric keys to enter the predetermined F-Code password.
NOTE: The password can be up to 20 digits in length and can include any combination of the
numerals 0 - 9 and the symbols * and #.
This password is not required if you agree in advance with the destination party not to use one.
8
Press the [Close] key. The message display will return to the same screen as was displayed in step
2. You can now change any transmission settings that you want or set the time for the transmission
to begin.
9
Press the Start key. The transmission operation will begin.
Printing Out Documents from an F-Code Confidential Box
Perform the following procedure to print out documents that have been received into your F-Code
Confidential Box. If the documents are printed out correctly, the data will be deleted from that box.
If you are using an F-Code Confidential Box for F-Code Based Bulletin Board Transmission and you
want to delete that data, simply print the documents out and the data will be deleted from that box.
NOTE: If you registered ‘0000’ as the F-Code password for your F-Code Confidential Box, it is not
necessary to enter a password just to print out documents from that box.
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode settings.
1
Press the [Application] key. The
Application screen will appear.
2
Press the [Sub.conf. box output] key.
3
Press the key that corresponds to the
desired F-Code Confidential Box if it is
highlighted. If the key is not highlighted,
there are no documents in that box.
Place the original & assign destination.
Dest
Ready for fax transmission.
Basic Application
Abbrev.
TXAddress
Register
settingbook
Print Report
Memor
To Next Page
Loading...
Need help?
General
