Fax Operation (Various Functions)
3-20
3
Press the [Yes] key. The selected communication will be deleted and the touch panel will return to
the initial mode settings.
If you want to continue deleting other scheduled communications, repeat steps 1 through 3.
Modifying the Contents of the Communication
You can modify the information relating to a scheduled communication that is presently saved in
memory. The scheduled time for the communication to start can be changed, destinations changed,
added and deleted, or the communication can be canceled completely. The actual procedure and
information available for modification is slightly different depending on the type of communication
involved. The example in the procedure below is for a scheduled Broadcast Transmission that uses
the timer. If you want to modify the information relating other types of communications, simply refer
to this example but follow the flow of the message display in order to perform the actual procedure.
NOTE: You CANNOT modify a scheduled communication that is waiting for Automatic Redialing,
nor is it possible to modify a scheduled Polling Communication, a scheduled transmission using the
Network FAX functions, a scheduled Broadcast Transmission, or an F-code Transmission.
If you want to cancel the procedure part way through, press the Reset key. The touch panel will
return to the initial mode settings.
1
Perform steps 1 through 3 of Printing Out a Sample Image of Waiting Documents on page 3-18.
2
Press the [Program/Change] key.
3
If you want to change the scheduled
start time, press the [Delayed TX] key
and then go to the next step.
If you want to modify the destination
information, press the [] key and then
go directly to step 6.
> Changing the scheduled start time
4
Use the numeric keys to enter the desired time for the communication to begin.
If you want to change the entered time, use the [W] and/or [X] keys to move the cursor to the
desired location.
5
Press the [Close] key. The message display will return to the same screen as was displayed in step
3.
If you also want to modify the destination information, press the [] key. If you do NOT want to
modify the information, go directly to step 14.
Close
To Next Page
Loading...
Need help?
General
