2L6/2N6/2N5/2N4
1-4-246
2. DP-scanning first (front) page
3. DP-scanning second (back) page (with a dual scan DP installed)
6
Wire rope Confirm that the wire rope has a
foreign object sticked or has a
scuff.
If a foreign object exists on the wire rope,
remove the foreign object. Or, if it is damaged,
replace.
Defective part Check description Corrective Action
1
DP conveying pul-
ley
Check that the conveying pulley
is smoothly operative.
If the conveying pulley does not rotate
smoothly, re-asslemble the conveying roller
and springs.
2
Adjustment height
of the hinge
portions of the DP.
Check the height of the front and
back portions of the DP.
If the front and back side of the DP is not
leveled, adjust the hinge on the left side.
3
Install DP Check how DP is mounted on
the main unit.
If mounting to the main unit is improper, check
positioning and secure the screws.
4
DP hinge
Check that the DP hinge is
operative in both ascending and
descending directions and kept
open.
If the DP is not operative smoothly or is not
held stably open, replace the hinges.
5
DP document mat Check the location the document
mat of the DP is mounted.
Re-mount the document mat of the DP if it is
hanged off.
6
Original document Check that the leading edge of
the original document is dog-
eared.
If the leading edge of the original documet is
dog-eared, straighten.
7
Scanning guide Check if the scanning guide is
distorted.
If the scanning guide deformed, replace.
8
Scopper guide Check that the scopper guide is
smoothly operative.
If the scopper guide does not rotate smoothly,
re-install.
9
Conveying roller
(before and after
portions of
scanning)
Check whether the conveying
roller is dirty.
If the conveying roller is dirty, clean.
10
Drive belt Check if the drive belt is jumping
gear teeth.
If the drive belt is jumping gear teeth, re-mount
the belt tensioner.
Defective part Check description Corrective Action
1
DP conveying pul-
ley
Check that the conveying pulley
is smoothly operative.
If the conveying pulley does not rotate
smoothly, re-asslemble the conveying roller
and springs.
2
Install DP Check how DP is mounted on
the main unit.
If mounting to the main unit is improper, check
positioning and secure the screws.
Defective part Check description Corrective Action
To Next Page
Loading...
