Kyocera TASKalfa 5551ci - Page 315

2L6/2N6/2N5/2N4
1-4-314

shown on the MFP
application.
Connection error of
the DVI cable (dam-
aged or loose con-
nected).
Defective DVI cable or poor
contact.
Reinsert the connector. Also
check for continuity within the
connector cable. If none, replace
the cable.
Connection error of
the network cable
(damaged or loose
connected).
Local network cable failure
or loose connection.Failure
or wrong version.
Reinsert the network cable. Also
check for continuity within the
connector cable. If none, replace
the cable.
Connection error of
the network.
Network settings are incor-
rect with the MFP.
Check network cable connec-
tion or replace.
[System Menu]
[System]
Enter LoginUserName and
LoginPassword and login.
[NetWork]
[TCP/IP Setting]
TCP/IP :ON
IPv4 DHCP :ON
AutoIP :ON
IPv6 :ON
[Protocol Settings]
HTTP :ON
Enhanced WSD :ON
Network settings are incor-
rect with the PC.
Perform the following steps.
[Network Connection] on the
control panel
[Local Area Connection]
(Properties)
[Internet Protocol] (TCP/IP)
(Properties)
Check [Resolve the IP
address automatically].
FW version mis-
match.
The version does not match
with the MFP firmware and
the Printing system firm-
ware.
See item 7 above.
Problem/
Error code
Condition of
detection
Causes
Check procedures/ Corrective
measures