2KN/2KP
1-5-64
5. Remove each two screws and then remove
the fuser thermostat 1 and 2.
6. Check or replace the fuser thermostat 1 and
2 and attach the thermostat 1 and 2 to the
fuser unit.
When attaching fuser thermostats 1 and 2,
check that each spacer plate and spacer
plate R is located in the right attachment
position aligned with the corresponding
marking position. Three combinations of
mounting positions, which vary with the
fuser unit, are prepared for each spacer
plate and spacer plate R.
7. Refit the upper fuser cover to the fuser unit.
8. Refit the fuser unit.
Figure 1-5-133
Marking Marking
Installation position (example)
Fuser thermostat 1
Fuser thermostat 1 or 2
Fuser thermostat 2
Screws
Screws
Spacer plate R
Spacer
plate R
Spacer plate R Spacer plate
Spacer
plate
Spacer plate R
Spacer plate
Spacer plate
To Next Page
Loading...
