Kyocera TASKalfa 620 - Page 300

2KN/2KP
1-5-80
5. Remove the CIS SHD PWB and flexible flat
cable from CIS.
Figure 1-5-165
6. Remove the connector and two screws and
pull out CIS from DP.
Note the position of the graduation of the
retainer.
7. Clean or replace CIS.
Figure 1-5-166
8. Connect one end of the flexible flat cable to
the CIS.
Figure 1-5-167
Flexible flat cable
CIS
CIS SHD PWB
CIS
Connector
Graduation
CIS
Flexible
flat cable