Kyocera TASKalfa 620 - Page 417

2KN/2KP-1
2-4-5
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Develop-
ing section
Developing unit Replace Every service Replace after feeding 500,000
sheets.
P.1-5-48
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Transfer
section
Transfer belt Replace Every service Replace after feeding 500,000
sheets.
P.1-5-51
Transfer roller Replace Every service Replace after feeding 500,000
sheets.
P.1-5-53
Idle belt roller Clean Every service Clean with a wet cloth and then a
dry cloth.
Transfer belt roller Clean Every service Clean with a wet cloth and then a
dry cloth.
Transfer ground roller Clean Every service Clean with a wet cloth and then a
dry cloth.
Check the continuity between roller
and ground screw.
Transfer rear guide Replace Every service Replace after feeding 500,000
sheets.
Transfer rear brush Clean Every service Clean with alcohol or a dry cloth.
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Cleaning
section
Cleaning unit Replace Every service Replace after feeding 500,000
sheets.
P.1-5-54
Cleaning lamp Clean Every service Clean with a dry cloth.
Section
Maintenance
part/location
Method
Maintenance
cycle
Points and cautions Page
Charge
erasing
section
PTC unit Clean
Check and
replace
Every service Clean the shield with a wet cloth
and then a dry cloth. Replace after
feeding 500,000 sheets.
P.1-5-56
PTC cleaning pad Replace Every service Replace after feeding 500,000
sheets.
P.1-5-56
PTC wire Replace Every service Replace after feeding 500,000
sheets.
P.1-5-57