2KN/2KP
1-3-31
U071
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Completion
Press the stop/clear key at the screen for selecting an item.
The screen for selecting a maintenance item No. is displayed.
U072
Adjusting the DP original center line
Description
Adjusts the scanning start position for the DP original.
Purpose
Make the adjustment if there is a regular error between the centers of the original and the copy image when
the optional DP is used.
Adjustment
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to be adjusted.
3. Press the interrupt key.
4. Place an original on the DP and press the start key to make a test copy.
5. Change the setting value using the cursor up/down keys.
For copy example 1, increase the value. For copy example 2, decrease the value.
Figure 1-3-13
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Completion
Press the stop/clear key at the screen for selecting an item.
The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
U071
U404
(P.1-3-81)
Display Description Setting
range
Initial
setting
Change in
value per step
ADJUST DATA Center line for the simplex copy mode -39 to +39 0 0.17 mm
ADJUST DATA2 Center line for the duplex copy mode -39 to +39 0 0.17 mm
ADJUST DATA3 Center line for rotate copying -7 to +7 0 0.084 mm
Original Copy
example 1
Copy
example 2
Reference
U072
U404
(P.1-3-81)
To Next Page
Loading...
