2KN/2KP
1-3-35
U080
Adjusting exposure in eco-print mode
Description
Adjusts the image density in the eco-print mode.
Purpose
To increase or decrease the image density in the eco-print mode.
Method
Press the start key. The screen for adjustment is displayed.
Setting
1. Change the setting using the cursor up/down keys.
Increasing the setting makes the image darker; decreasing it makes the image lighter.
2. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in the interrupt copying
mode.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U087
Setting DP reading position modification operation
Description
The presence or absence of dust is determined by comparing the scan data of the original trailing edge and
that taken after the original is conveyed past the DP original scanning position. If dust is identified, the DP
original scanning position is adjusted for the following originals.
Purpose
When using DP, to solve the problem when black lines occurs due to the dust with respect to original reading
position.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select CCD at the screen for selecting an item.
2. Change the value using the cursor up/down keys.
3. Press the start key. The value is set.
Clearing
1. Select BLACK LINE at the screen for selecting an item.
2. Select CLEAR.
3. Press the start key. The setting is cleared.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Setting Setting range Initial setting
Exposure is toner economy mode -12 to 0 -5
Setting Setting range Initial setting
Black line inspection 0 to 255 200
To Next Page
Loading...
