2KN/2KP
1-3-36
U089
Outputting the MIP-PG pattern
Description
Selects and outputs the MIP-PG pattern created by the copier.
Purpose
To check copier status other than scanner when adjusting image printing, using MIP-PG pattern output (with-
out scanning).
Method
1. Press the start key.
2. Select the MIP-PG pattern to be output.
3. To change the output conditions of MONO-LEVEL, 1dot-LINE and VTC-PG, change the preset values
using the cursor up/down keys and press the start key to register the setting.
4. Press the interrupt key. The copy mode screen is displayed.
5. Press the start key. A MIP-PG pattern is output.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display PG pattern to be output Purpose
GRAYSCALE To check the laser scanner unit
engine output characteristics.
MONO-LEVEL To check the drum quality.
256-LEVEL To check resolution reproduc-
ibility in printing.
1dot-LINE To check fine line reproducibility.
To adjust the position of the
laser scanner unit (lateral
squareness)
VTC-PG
Setting Setting range Initial setting
Output density of MONO-LEVEL 0 or 70 0
1dot-LINE 0 to 21 0
VTC-PG 0 to 12 0
To Next Page
Loading...
