2.SETTING ITEMS (ADMIN)
IEEE 802.1X Authentication Setting 149
2 SETTING ITEMS (ADMIN)
2
Specify the following items as required and press [Next].
[EAP-USER NAME] — Press this button to enter the EAP-User name.
[PASSWORD] — Press this button to enter the authentication password.
[RETYPE PASSWORD] — Press this button to re-enter the authentication password.
When you press the above buttons, the on-screen keyboard is displayed. Enter a value using the keyboard and
digital keys, and press [OK] to set the entry.
3
Confirm the settings and press [APPLY NOW].
The “NETWORK INITIALIZING” message is displayed and this equipment starts initializing the network interface
card to apply the changes.
[CRL Verification] shows whether the certificate revocation list (CRL) is enabled or disabled. To use CRL, it is
necessary to upload the certificate revocation list to the equipment from the COMMAND CENTER - Security
Service menu. Changing the CRL verification option from [Enable] to [Disable] or vice versa is also performed
from COMMAND CENTER. For details, refer to the COMMAND CENTER Guide.
Error messages
The following error messages may be displayed on the touch panel.
Message Cause
[802.1X] Auth Server/Switch couldn’t be contacted y The RADIUS server service is stopped.
y Configuration for the RADIUS server is not correct.
y The IEEE 802.1X switch has problem.
[802.1X] Authentication failed y The username or password that the user entered is not
correct.
y The certificates uploaded are wrong.
[802.1X] Falling back to non-802.1X mode Network communication has begun using the fall back function,
ignoring IEEE 802.1X authentication.
To Next Page
Loading...
