2 SETTING ITEMS (ADMIN)
98 Setting Network Functions
5
Continue to another network setting if required, then press [APPLY NOW].
The “NETWORK INITIALIZING” message is displayed and this equipment starts initializing the network interface
card to apply the changes.
If Duplicate Address Detection (DAD) detects duplicate addresses, the message “IPv6 ADDRESS CONFLICT”
is displayed on the touch panel.
Setting the IPX/SPX protocol
You can set the IPX/SPX protocol on this equipment. The IPX/SPX protocol is usually used to communicate with the
NetWare file server through the network.
1
Press [NETWORK] in the ADMIN menu.
The NETWORK menu is displayed.
To display the ADMIN menu, see the following page:
P.63 “Entering Admin Menu”
2
Press [IPX/SPX].
The IPX/SPX screen is displayed.
To Next Page
Loading...
