2.SETTING ITEMS (ADMIN)
Setting Network Functions 95
2 SETTING ITEMS (ADMIN)
4
Specify the following items as required.
KEEP CONFIGURATION — Select the method for handling IPv6 address data when a new IPv6 address is
provided from the same router providing the current IPv6 address to this equipment. Press [ENABLE] to retain the
current IPv6 address data and add the new IPv6 address to this equipment. Press [DISABLE] to overwrite the
current IPv6 address data with the new IPv6 address.
DHCP (IP Address) — Press [ENABLE] to use the IPv6 address issued from the DHCPv6 server in a stateless
network environment, or [DISABLE] not to use it.
DHCP (OPTIONS) — Press [ENABLE] to use the optional information (IPv6 address for the DNS server, etc.)
issued from the DHCPv6 server in a stateless network environment, or [DISABLE] not to use it.
When you select [ENABLE] for the DHCP (IP Address) option, [ENABLE] is automatically set for the DHCP
(OPTIONS) option.
5
Press .
IPv6 addresses obtained from routers are displayed.
Up to 7 IPv6 addresses can be retained.
When this equipment receives a router advertisement (RA) from a router with an M flag configuration of “0”, the
DHCPv6 function is disabled. If you change a router advertisement (RA) M flag configuration from “0” to “1”,
reboot this equipment by using the [POWER] button on the control panel to enable the DHCPv6 function.
6
Press [OK].
You will be returned to the NETWORK menu.
To Next Page
Loading...
