Kzyee KM301 - Page 27

OBD & Battery Analysis Scanner
- 25 -
Tool Self-test
From System Setup, select Tool Self-test, then press OK.
Display Test
1. From Tool Self-test, use the Up/
Down button to select
Display Test, then press OK.
2. Toverify that the LCD screen is
functioning properly, a color test will run.
3. Press ESC to exit the test.
Display Test
Keyboard Test
LED Test ?
Tool Self-test 1/3
Keyboard Test
Figure 61
1. From Tool Self-test, use the
Up/ Down button to select
Keyboard Test, then press OK.
2. Press each button to make sure they are
functioning properly. If functioning
properly, the correct name for each
button will display after the word “key:”.
3. Press ESC twice to exit the test.
LED Test
Figure 62
1. From Tool Self-test, use the Up/
Down button to select LED
Test,then press OK.
2. Toverify that the LEDs are functioning
properly, select each LED then
press OK. If functioning properly,
the selected LED will light up.
3. Press ESC to exit the test.
Figure 63
Keyboard Test
Press any key to
start test
key:
Double [ESC] to return
RED LED ON
YELLOW LED ON
GREEN LED ON
1/3
LED Test