3. Getting Started
25
Kinetic
Kinetic Cycle
Use the program element Kinetic Cycle to perform several consecutive
measurements, which may be executed in certain intervals.
Enter the respective parameters:
Cycles Number of cycles: Enter a number or click the up or
down arrows for the number of actual measurement
steps (2 – 1000 cycles)
Duration: Enter the duration, format hh:mm:ss.
Kinetic Interval Use kinetic interval: Enter the time interval
(hh:mm:ss or ms).
Kinetic Condition
Use the Kinetic Condition program element to define which actions should be
executed at a certain cycle.
If 2 is entered for Execute command at cycle within a kinetic measurement
containing, e.g. a Shake step, shaking is performed only at cycle 2.
Note
Kinetic conditions such as Shake should be inserted right after a Kinetic
Cycle program element in order to ensure optimal result reproducibility.
Users are advised to set up suitable scripts prior to the measurements
and to use the same script for all similar kinetic measurements in order
to obtain comparable results.
To Next Page
Loading...
Need help?
General