LAIKA Kosmo Compact 9 - Ecovip A-Class and Kreos A-Class Cab; Heating; Heating of the Rear Bed Area (Kreos); Heating of the Rear Bed Area (Kosmo)

13.2.1 Ecovip A-class and Kreos A-class
cab heating
In Ecovip A-class and Kreos A-class models with Alde
heating system, it is possible to turn on extra heating
fans under the cabin seats.
To activate the heating fans, press the switch located on
the base of the right cabin seat. You can select two fan
speeds: press part (a) for a higher speed or part (b) for a
lower speed. To turn off the heating fans, place the
switch in the middle position ("0").
13.2.2 Heating of the rear bed area
(Kreos)
On the models Kreos 5009, 5010, 7009, 8009 there is
a knob present which permits an independent
regulation of the heating in the rear bed area, in
confront to the rest of the living area.
The Alde heating knob is located inside the rear
bedroom. By selecting the lowest value (*) you will
obtain the complete exclusion of the rear bed area from
the heating circuit, whilst raising the values, the heating
will increase in this area until complete alignment with
the rest of the living quarter (maxium value).
13.2.3 Heating of the rear bed area
(Kosmo)
On the models of Kosmo series it is possible to exclude
the heating of the rear bed area by turning valve (a). This
valve is located inside the rear bedroom.
13 - HEATING SYSTEM
74
USER’S GUIDE
On the Kreos 8002, 8009, 8012 the switch is
placed behind the right cabin seat.
NOTE
a
a
b
Ecovip A-class
b
a
Kreos A-class