EasyManuals Logo

Lantech IPES-5408T User Manual

Lantech IPES-5408T
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
99
Specify the priority1 value to override the default criteria (clock quality, clock
class, etc.) for best master clock selection. Lower values take precedence. The range
for both is from 0 to 255., The default is 255
Priority2:
Specify a priority2 value to be used as a tie-breaker between two devices that
are otherwise equally matched in the default criteria. For example, you can use priority2
value to give a specific switch priority over other identical switches. The range for both
is from 0 to 255. The default is 255.
Announce Interval:
Specify the time for sending announce messages. The range is 0 to 4 seconds.
The default is 1 (2 seconds).
Announce Interval Timeout:
specify the time for announcing timeout messages. The range is 2 to 10 seconds.
The default is 2 (4 seconds).
Sync Interval:
enter the time for sending synchronization messages. The range is -1 second to
1 second. The default is 1 second.
Delay Request Interval:
specify the time recommended to the member devices to send delay request
messages when the port is in the master state. The range is -1 second to 6 seconds.
The default is 1 (2 seconds).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantech IPES-5408T and is the answer not in the manual?

Lantech IPES-5408T Specifications

General IconGeneral
BrandLantech
ModelIPES-5408T
CategorySwitch
LanguageEnglish