EasyManuals Logo

Lantech IPES-5408T User Manual

Lantech IPES-5408T
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
58
Mirrpr From:You can set which switch port will be duplicated then send to the
destination port.
Note1 : All the duplicated data of the source port can be separated with RX and
TX, if you want to collect multi-source ports at the same time, you can assign the
Tx of one destination port to be responsible for collecting all the Tx data of
source ports and assign another RX of destination port to be responsible for
collecting all the Rx data of source ports.
And then, click
Apply
button.
6.6.6 Rate Limiting
You can set up every ports bandwidth rate and frame limitation type.
All the ports support port egress/Ingress rate control. For example, assume port
1 is 10Mbps, users can set it’s effective egress rate is 1Mbps, ingress rate is
500Kbps. The switch performs the ingress rate by packet counter to meet the
specified rate
Click
Apply
to apply the settings

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lantech IPES-5408T and is the answer not in the manual?

Lantech IPES-5408T Specifications

General IconGeneral
BrandLantech
ModelIPES-5408T
CategorySwitch
LanguageEnglish