60
6.7 Power over Ethernet (only available for IPES series)
This segment shows the PoE(Power over Ethernet) function complying with IEEE
802.3af/at standards
6.7.1 Configuration
Maximum Power Available:
This function will limit the total power consumption and cannot exceed 250W.
Port No.
The number of each PoE port
Enable
Enable/disable the PoE function of each PoE port
Priority
Set the priority of power supply, if the total power consumption of all PoE ports
was over the value of maximum power available, the switch will offer the power
to the high priority PoE port and stop to supply power to the low priority PoE port.