102
Role
It can be either RPL owner or RPL Neighbor.
Type
Type of Protection ring. It can be either major ring or sub-ring.
Ring Port 0
This will create a Port 0 of the switch in the ring.
Ring Port 1
This will create "Ring Port 1" of the switch in the Ring.
Node Failure Protection
This option can prevent the event that all switches in the same ITU ring reboot
together to cause ITU Ring fail by finding no owner initiated where can be applied in
the case of power breakout and all switches are powered back at the same time.
The default Node failure protection is disabled, please allow 70 seconds boot up time
if you enable such function.
Detect Misswiring
This function can prevent the user use the incorrect port as ring port to cause the
network in loop status.
To Next Page
Loading...
General