Proline Kryomats
32 Starting up YAUE0007 / 2/26/2009
1 s
− An acoustic signal is emitted for about 1 second.
− It is quite normal if the refrigerating machine makes a rattling sound
for a few seconds.
− The unit starts its self-test. All display segments and symbols
appear for about 1 second.
− The momentary bath temperature is displayed,
− the pump starts provided "Standby" or "Manual start" (Ö 7.6.1) has
not been p
rog
rammed,
− all values are accepted which were active before switch-off.
Check or set overtemperature cut-off point:
− The switching point is shown in the LED display on pressing the key
.
− Change overtemperature cut-off (Ö 7.12.1). Overtemperature
protection and che
cking on page 75.
)
− If necessary, top up heat transfer liquid, this has been pumped out
by filling the external load.
− Display for
KDTDK (low level) appears when the bath has too
little liquid.
− Red LED
above the fault triangle flashes.
− Find cause of fault and, where necessary, top up missing heat
transfer liquid (Ö 6.3).
− Press the Enter key.
− Also, pre
ss the key if unit has been switched off in the fault state.
− No release is possible
on Command control element!
Command
− Language
− If the Command Console is being
switched on for the first time, the
illustrated window appears automatically,
enabling you to select the dialog language
with the appropriate soft key.
Self-test
77(((
°C
EXT
Bath temperature
/1%21
°C
Level alarm
KDTDK
°C
Overtemp. cut-off
8/
°C
English
Deutsch
Français
Español
To Next Page
Loading...
Need help?
General
