Proline Kryomats
YAUE0007 / 2/26/2009 Brief operating instructions 9
2 Brief operating instructions
These brief instructions shall give you the possibility to operate the unit quickly. For safe
operation of the unit, it is necessary to read carefully all the instructions and safety
notes!
1. Assemble unit and add items as appropriate (Ö 6.1).
The unit may NEVER be overturned nor put upside down!
Take care of the ho
se tubing connections (Ö 6.3 and 6.4).
2. Fill the unit with corresponding heat transfer liquid (Ö 6.3). The units are designed for
operation with non-flammable and flammable liquids to DIN EN 61010-2-010. Æ Take care
of the level of the heat transfer liquid! (Ö 6.2).
3.
Compare the information o
n the rating label with the supply details.
4. Connect the unit only to a socket with a protective earth (PE) connection.
5. Check whether the switch
at the back of the master control element is in
the "ON =
–" position.
6. Check whether the switch
at the front of the master control element is in the "ON = l"
position.
7. Set the rotary switch
on the front panel to "ON = l". The unit starts
operating.
8. With
set the overtemperature cut-off point to a value clearly above room temperature
(Ö 7.12.1).
9. Now you see the curre
nt bath temperature in the
display, for example:
If instead, a warning or error message is displayed, then refer to Section 7.12.
Bath-temperature
/1%21
°C
To Next Page
Loading...
Need help?
General
