Proline Kryomats
YAUE0007 / 2/26/2009 Starting up 71
7.10 Timer function (Command)
Using the timer function, the thermostat can carry out an action at a certain time or after a certain
waiting period. The actions are: switching on the thermostat, entering the standby mode or one of the 5
programs in the programmer.
Command
− Clock Timer 1 Timer 2
− Open the device parameter menu via the
soft key Menu .
− With the cursor keys continue to:
Æ Clock Æ Timer 1 ,
− or to Timer 2 ,
− with the menu Status the selected timer
is switched off or on .
− The standby key does not stop the
timer!
Please exercise caution when thermostat is in standby mode. (Ö 7.5.3)
A previously activated timer mode
could unintentionally start the thermostat again from
the standby mode.
− The menu Function is used to define
when an action is executed:
− Similar to an electronic mains timer,
Weekplan enables two switching events
to be carried out each day. The cycle is
repeated after 7 days.
− Time absolute defines a time and a date
on which a once-only action (switching
event) occurs. The time point is set with
Set time and with Set date .
− Time relative defines a waiting period
after which a once-only action occurs.
With Set time up to 99h: 59min can be
entered. ("Set date" is masked out with
this function selection).
− If the Weekplan is activated, in this
window only Status , Function and
Weekplan are displayed.
Hel
Menu End T
set
T
fix
Set time
Set date
Timer 1
Timer 2
Format of date
Pump
Settings
Graph
Clock
Programmer
Interfaces
Control
Limits
Hel
Menu End T
set
T
fix
Weekplan
Time absolute
Time relative
Status
Function
Action
Set Time
Set Date
To Next Page
Loading...
Need help?
General
