Leibinger JET3 up - Page 129

Service Manual JET3
Rev. 1.0 129
Screw in the 2 screws for the mounting of the motor with the allen key (SW 1,5 mm)
completely again.
Pull in the safety pin and fixed them
with the locking ring again.
Screw in the screws (2x) in the retaining
plate again.
12. Cut off the inside end of the flexible tube and put it on the gutter tube again.
13. Plug in the main plug again and switch on the printer.
Confirm the message “printer switched off with emergency shutdown” with the button
<OK> (1). In the second step confirm also the error message 5016 “nozzle was opened
during start up of the printer” with the button <Quit> (2).
1 – Button <OK>
2 – Button <Quit>
1
2