Leibinger JET3 up - Page 130

Service Manual JET3
130 Rev. 1.0
Information
The printer will now check if he can drive the travel range and will drive
automatically into the position zero to close the nozzle.
During the booting process the values of the nozzle encoder were set to
zero and the shown value is the right again.
14. After that you must check the ink stream position. Push the button <Jet Adjust> (1).
The printer will drive to pre defined service position (2).
1 – Button <Jet Adjust>
2 – Display field <Service Position>
15. Check the ink stream position.
Information
Look at chapter: Print head adjustment on page 109.
1
2