Leibinger JET3 up - Page 146

Service Manual JET3
146 Rev. 1.0
4. Remove the return flow tube on the blue tube connector and connect a piece of tube on
these connector (please see the following pictures).
5. Put the end of this tube into an empty ink or solvent bottle and press the button <Next>
(1) to start the routine.
6. Dependent on the filling level of the ink tank, the routine may run a few minutes.
If the level sensor of the ink tank signals “low level”, the routine runs another 120 sec.
till the message „ink tank is empty“ appears automatically and switches off this routine.
1