Leibinger JET3 up - Page 32

32
Service Manual JET3
20-24
20=Internal interface error
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Reboot again the system.
Carry out a software update.
Change the controller board.
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER
100-104
100=Internal communication
error
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Reboot again the system.
Carry out a software update.
Change the controller board.
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER
105
105=Internal communication
error.
Too much data.
Internal communication problem.
Internal message at the receiver was too
large (currently 1MB)
Check files on maximum size of 1
MB. fonts, graphics, or job
109/110
109=Internal communication
error
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Reboot again the system.
Carry out a software update.
Change the controller board.
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER