Leibinger JET3 up - Page 34

34
Service Manual JET3
114
114=Internal communication
error
Internal communication problem:
The lenght of a single packet doesn't fit in
the length.
Read the script and interface
protocol documentation!
If no success, please contact
LEIBINGER
115-124
115=Internal communication
error
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Reboot again the system.
Carry out a software update.
Change the controller-board.
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER
1000
1000=Joblist could not be
loaded
The RIP was unable to load the job list
(faulty job list!) Possible caused by
manually-created job list.
Check the job-list and job
parameter again.
1001
1001=Script begin job
syntax error
Syntax error in beginning of job script
Read the script and interface
protocol documentation!
1002
1002=Jobparameter syntax
error
Syntax error in job parameters.
Read the script and interface
protocol documentation!
1003
1003=Counter variable
syntax error
Syntax error in counter variable.
Read the script and interface
protocol documentation!
1004
1004=Barcodeobject syntax
error
Syntax error in the bar code object.
Read the script and interface
protocol documentation!
1005
1005=Textobject syntax
error
Syntax error in the text object.
Read the script and interface
protocol documentation!
1006
1006=Replacement syntax
error
Syntax error in substitution variable.
Read the script and interface
protocol documentation!
1007
1007=Timevariable syntax
error
Syntax error in date time variable.
Read the script and interface
protocol documentation!
1008
1008=Shiftvariable syntax
error
Syntax error in shift code variable.
Read the script and interface
protocol documentation!