Leibinger JET3 up - Page 37

37
1210
1210=PrintGo error
"PrintGo error."
Another print go signal was detected while
the system is printing.
- Several print go from same product
- distance between sensor and print head is
too big
1. Adjust the print go sensor that
one product is sending only one
signal.
2. Reduce the distance from
sensor to print head.
3. Use print go hold function
See 0perating manual JET3up
Figure 8.5.1.4 / Page
196ReleaseR1.06
1211
1211=Internal
communication error
Softwareupdate!
Carry out a software update.
1212
1212=Internal
communication error
Internal communication problem:
A CPU (RIP) has sent a message (identifier)
to a different CPU which is unknown.
Reboot again the system.
Carry out a software update.
Change the controller board.
See the service document
"Exchange the Controller board
JET3up"
If no success, please contact
LEIBINGER
1213
1213=Job data too large
A job is bigger than 1 MByte.
Check the size of the print job and
reduce if necessary.
Read the script and interface
protocol documentation!
1214
1214=Too much strokes in
one job
more as 20000 strokes are used within the
job
Read the script and interface
protocol documentation!
1215
1215=Empty joblist
Empty job list.
Read the script and interface
protocol documentation!
1216
1216=Faulty RIP memory
reservation
Error in RIP memory reservation.
Read the script and interface
protocol documentation!