Leibinger JET3 up - Page 46

46
Service Manual JET3
5020
5020=HV-Current too high.
Check deflection plate for
dirt or humidity.
Causes:
1. Dirty deflection plates
2. Head with ink or solvent filled
3. Error of the assembly
(usually squeezed HV cable)
Clean the print head
5030
5030=Error.
A StrokeGo occured while a
stroke was in progress. So
strokes will be lost.
Error. A StrokeGo occured while a stroke
was in progress. So strokes will be lost
because of too high production speed.
Reduce the production speed if
possible.
Increase the stroke distance if
possible.
Use a different speed mode to get
a higher possible production
speed.
Use a smaller font in the print job
to reduce the maximum size of
drops in the height.