Leica mojo3D, Correction Sources 213
Configuring
GL1DE
TM
as a fall-
back, step-by-step
If Network DGPS, Network RTK or RTK Base Station (Internal Radio) is configured as
the correction source for a mojo3D system, then the operator has the option to
configure GL1DE
TM
as the fallback position type should the other one fail.
To configure GL1DE
TM
as the fallback position type, carry out the following steps:
1. At the main navigation screen, tap the settings button.
2. On the flyout menu tap the correction source button.
The Correction Source screen appears.
3. Tap the button until you get to the Enable GL1DE Fallback screen.
4. To enable GL1DE
TM
Fallback tap the
Enable GL1DE
TM
Fallback box so it
turns green.
To Next Page
Loading...
