Leica mojo3D, Running the mojo3D for the First Time 37
• Areas may be measured in metric, Imperial, or US Standard units. The Imperial
acre is the defined international acre, and the US acre is the slightly smaller US
Survey acre.
2. After making your selections, tap to continue.
Mode selection,
step-by-step
1. On the mode selection screen, tap the buttons to select:
• top-down mode: either north is at the top of the map screen, or the direction
of the front of the vehicle is at the top of the map screen, and
• display mode: day mode, night mode, or automatic switch between modes.
2. After making your selections, tap to continue.
Lightbar mode
setup,
step-by-step
The default lightbar mode is the Leica Geosystems Smart lightbar which uses both
cross track error and heading error to guide you to the line. The other choice offered
is the traditional Crosstrack only lightbar.
To configure the lightbar settings, carry out the following steps:
1. On the Lightbar Mode screen, select:
• Smart to use the smart lightbar, or
• Crosstrack to use the traditional cross track lightbar.
2. If you selected Smart, tap to continue through the System Settings Wizard.
To Next Page
Loading...
Need help?
General
