Step6.Removethedrivesfromthedrivebackplaneassembly(see“Removingahot-swapharddiskdrive”
onpage210
)andinstalltheminthenewbackplaneassembly.
Step7.Disconnectthecombinationpower/configurationcablefromthebackplaneassembly.IfSASsignal
cablesareattachedtothedrivebackplane,disconnectthem.
Step8.Liftupthespringreleaselatchslightlywhilepushingtheassemblyfromthebackandslidethe
backplaneassemblyoutthefrontoftheserver.
1.8-inch
filler panel
8x1.8-inch
drive backplane
assembly
Release latch
Figure184.Backplaneassemblyremoval
Ifyouareinstructedtoreturnthedrivebackplane,followallpackaginginstructions,anduseanypackaging
materialsforshippingthataresuppliedtoyou.
Replacingthe8x1.8-inchSSDbackplaneassembly
Usethisinformationtoreplacethe8x1.8-inchSSDbackplaneassembly.
Attention:
1.Beforeremovinganycomponentsordisconnectinganycables,keepnoteoftheirrespectivelocations
andhowtheyareconnectedtothesystemboard.
Toreplacethe8x1.8-inchhot-swapSSDbackplaneassembly,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”
onpage34
.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercordsandallexternalcables,
ifnecessary.
Step3.Removethecover(see“Removingthecover”onpage195).
Step4.Alignthedrivebackplaneassemblywiththedrive-bayslotsinwhichyouwanttoinstallthe
assembly.
Chapter6.Removingandreplacingcomponents263
To Next Page
Loading...
