Lenovo System x3650 M4 HD - Removing a Usb Embedded Hypervisor Flash Device

0000
0000
0000
0000
0000
0000
0000
0000
0000
1.8-inch
filler panel
8x1.8-inch
drive backplane
assembly
Figure185.Backplaneassemblyinstallation
Step5.Slidethedrivebackplaneassemblyintotheslotuntilitclicksintoplace.
Step6.Connectthecombinationpower/configurationcabletotheconnectorsonthebackplaneassembly;
thenconnectthesignalcablestothebackplaneassembly(asshownintheillustration).
Note:Youcanreconnectthecablestothedrivebackplanebeforeinstallingthebackplaneontothe
cageoryoucanconnectthecablesafteryouinstallthebackplane,ifthatiseasierforyou.
Step7.Reinstallthedrivesthatyouremovedfromtheoldassemblyintothenewdrivebackplaneassembly
(see“Replacingahot-swapdrive”onpage211).
Step8.Installthedrivefillerpanel.
Step9.Installthecover(see“Replacingthecover”onpage196).
Step10.Slidetheserverintotherack.
Step11.Reconnectthepowercordsandanycablesthatyouremoved.
Step12.Turnontheperipheraldevicesandtheserver.
RemovingaUSBembeddedhypervisorflashdevice
UsethisinformationtoremoveaUSBembeddedhypervisorflashdevice.
ToremoveaUSBhypervisorflashdevice,completethefollowingsteps:
Step1.Readthesafetyinformationthatbeginson“Safety”onpagevand“Installationguidelines”
onpage34.
Step2.Turnofftheserverandperipheraldevicesanddisconnectthepowercords.
Step3.Removethecover(see“Removingthecover”onpage195).
Step4.Removetheflashdevice:
264LenovoSystemx3650M4HDInstallationandServiceGuide