Note: See your client's online help for how to configure the console port.
Step 6. Assign an initial controller management IP address to one of the controllers.
If the management network has DHCP...
Then...
Configured
Record the IP address assigned to the new
controller modules.
Not configured
1. Open a console session using PuTTY, a
terminal server, or the equivalent for your
environment.
Note: Check your client's online help if
you do not know how to configure PuTTY.
2. Enter the management IP address when
prompted by the script.
Step 7. Using System Manager from your client, configure your cluster:
a. Point your browser to the controller management IP address (from Step 6).
Note: The format for the address is https://x.x.x.x.
b. Configure the system using the data you collected in the Cluster configuration worksheet.
Chapter 4. System installation and setup 25
To Next Page
Loading...
Need help?
General