If the system-level diagnostics tests...
Then...
Were completed without any failures
1. Clear the status logs: sldiag device
clearstatus
2. Verify that the log was cleared: sldiag
device status
The following default response is
displayed:
SLDIAG: No log messages are present.
3. Exit Maintenance mode on both
controllers: halt
The system displays the LOADER prompt.
Attention: You must exit Maintenance
mode on both controllers before
proceeding any further.
4. Enter the following command on both
controllers at the LOADER prompt: boot_
ontap
5. Return the controller to normal operation:
If your system is
running ONTAP...
Then...
With two controllers
in the cluster
Issue these
commands:
node::> cluster ha
modify -configured
true
node::> storage
failover modify
-node node0
-enabled true
With more than two
controllers in the
cluster
Issue this command:
node::> storage
failover modify
-node node0
-enabled true
You have completed system-level diagnostics.
Resulted in some test failures Determine the cause of the problem.
1. Exit Maintenance mode: halt
2. Perform a clean shutdown, and then
disconnect the power supplies.
3. Verify that you have observed all of the
considerations identified for running
system-level diagnostics, that cables are
securely connected, and that hardware
components are properly installed in the
storage system.
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
Need help?
General